2000 jeep grand cherokee drivers door wiring harness

It comes in an outer sheath that came in handy, because I ran it through the boot inside the kick panel area.

I used Belden two-conductor 14ga speaker cable I had leftover from a home theater job. trying to spice inside the doorjamb boot. Good to go!Īs others have suggested, it's worth running new wire from the speaker to the connector block vs. I wiggled the wires in the doorjamb until I got the second wire to beep intermittently. In my case, one was a good connection and the other bad, which told me that I was either on the right track since one of the speaker wires worked intermittently, or completely off base. Confirm that the wire in question is the right one. You may need a jumper wire/alligator clip if your multimeter wires won't reach.

Poke one end into the connector block and the other onto the end of your speaker wire. Grab a multimeter and set it to continuity mode.where it beeps when the circuit is complete. I noticed that my green and black/red striped wires were one gauge size larger than the other ones. Pop this connector out and examine the wires going into it. Instead of following them through the maze of cloth-wrapped wiring, I picked them up after they came through the door boot and traced them into a white connector block. When removing the speaker, take a look at what colors the wires are: mine were green and black with a red stripe. If you sit on the ground you'll have plenty of room to work, unless your lift is so high that you can stand up Tighten the strap and the bottom edge of the door panel moves away from the speaker, giving you about 6' of room. In order to keep it out of the way, I took a cheap non-ratchet tie down, hooked one end under the 'door grab' plastic piece that you use to pull the door shut, threw the other end over the top of the door, along the outside of the door and hooked the other end up to one of the holes that you'll now see in the door's sheet metal. If you're leery of removing the door handle attachment when taking off the interior door panel (I'm too big to climb over to the passenger side if I put the door handle mechanism on wrong ) you can leave the door panel loose, attached to the mirror and windows controls, the door handle and lock. I did my 97 XJ Country driver's speaker tonight and wanted to add: Snap the fasteners into place, put in the armrest screws, the screw behind the inside latch lever, and the one in the forward top corner. Reconnect the latch and lock levers, hook the top edge of the doorskin over the window sill and slide the skin into place, making sure all the snap fasteners are lined up with the holes in the door. Be sure to watch the lower edge of the window as it goes down and make sure you haven't left the cable where the lower edge of the window will catch on it or rub against it. When you have finished with the splices and pushed the boot back into place, reconnect the controls and roll the window down all the way. Just pull the seam open, and after you have spliced in new wires, just press the seam closed.Ĥ. After you move the boot out of the way do NOT cut the wrapping around the cable!! If you look closely with a strong light you will see a velcro-like seam along the whole length. This gives you much more room to reach in behind the speaker and manipulate the boot and cable.ģ. After you have lifted the skin off the door, but before you unplug the window control cables, roll the window up. Roll down the window before you remove the doorskin, because you cannot lift the skin up over the window lip with the window up.Ģ. This video is mostly correct, but it helps to note the following:ġ.

2000 jeep grand cherokee drivers door wiring harness