Write the UEFI firmware to the SD card, and then insert an USB drive with the standard NetBSD arm64.img written to it. The Raspberry Pi 4 requires the UEFI firmware. If you're not using NetBSD, your operating system's dd command's arguments may vary. $ dd if=armv7.img of=/dev/rld0d conv=sync bs=1m progress=1 The Raspberry Pi 3 can also use .ĭecompress it and write it to the SD card: $ gunzip.The Raspberry Pi 2-3 can use the standard ARMv7 image.The Raspberry Pi 1 requires the ARMv6.The simplest way is to download the appropriate SD card image from the NetBSD mirrors: Builds of NetBSD for earlier revisions of ARM are unsupported. In theory the code compiled for earmv7hf will be faster, but anecdotal experience is that it doesn't matter that much.

There will still be a kernel7, built to use the 2/3 hardware, but with the armv6 instruction set. Note that one can run a build of earmv6hf on the 2 and 3.

RPI4 uses 'aarch64' (ARMv8 CPU hardware).

RPI3 uses 'earmv7hf' or 'aarch64' (ARMv8 CPU hardware).

RPI2-1.2 uses 'earmv7hf' or 'aarch64' (ARMv8 CPU hardware).

Previously the driver was only included with 32-bit (ARMv7/ARMv6).

RPI4 Ethernet (Broadcom GENETv5) - genet(4) needs man page.

aarch64 support (RPI3, and should work on all supported systems with 64-bit CPUs).

I☬: works, could use enhancements, man page.

DMA controller driver and sdhc(4) support.

USB host controller - dwctwo(4) and most devices work.

GPU (OpenGL ES and video decoding acceleration) - vchiq(4).

via framebuffer (and llvmpipe on AArch64), X11 does not use the VideoCore GPU.

serial or graphics console (with EDID query / parsing).

root filesystem can be uSD or USB-attached mass storage.

boots normally to multiuser, with FAT32 boot partition on uSD.

RPI0 and RPI0W are expected to work (without WiFi, and one needs fdt files odo where from?).

RPI1, RPI2, RPI2-1.2, RPI3, RPI3+ (except RPI3 builtin WiFi and bluetooth).

( Raspberry Pi image by Christopher Lee used under CC-By-2.0 license) What works NetBSD 8

Xenon death flash (Raspberry Pi 2 is camera-shy).

Power supply needed (or: why there is a little rainbow square in the top-right corner?).Updating the firmware version in the NetBSD sources.

Setting up raspberry pi as emulator mac